• 2 ply belt flaps full width of floor
• Bolt on 5^th wheel
• Hydraulic Gear drive 130,000 in-lb, 18000 pound radial load
• 2 15/16 rear drive shaft, with weld on sprockets and weld on splined hub
• Top hinge hydraulic main gate, with center knife gate and cylinder locks, 12" clearance above top rail
• Plastic floor liner is UHMW 3/8" thick
• Sides fully lined with plastic 3/16 HMW to top
• Extended rear discharge with wings on rear of trailer
• Hydraulic pressure line filter, manual / electric control valve
• Hydraulic floor speed control
• Main frame rails and suspension sub-frame are steel 
• Side and slope sheets are post and hat riveted aluminum construction
• 50,000 pound landing gear
• ABS brake system
• 11 x 22.5 on 10 bolt hub pilot aluminum rims
• Hendrickson Intraax Air ride suspension with 25,000 pound axles
• Various axle combinations available
• Shur-lok roll tarp
• Dot lighting, Reflective tape
• Other options available