 |
Floor Chain is 88 XH Pintle Chain, 2 strands
|
|
Easy access belt adjustment at front of
trailer |
|
2 ply belt flaps full width of floor |
|
Bolt on 5thwheel |
|
Hydraulic Gear drive 130000 in-lb, 18000
pound radial load |
|
2 15/16 rear drive shaft, with weld on
sprockets and weld on splined hub |
|
Hydraulic top hinge Main gate, with center
knife gate and cylinder locks |
|
Plastic floor liner is UHMW 3/8 thick, sides
fully lined with plastic 3/16 HMW to top |
|
Extended rear discharge with wings on rear
of trailer |
|
Hydraulic pressure line filter, manual /
electric control valve |
|
Hydraulic floor speed control |
|
Main frame rails and suspension sub-frame
are steel |
|
Side and slope sheets are post and hat
aluminum construction, riveted |
|
50000 pound landing gear |
|
ABS brake system , Dot lighting, Reflective
tape |
|
11 x 22.5 on 10 bolt hub pilot aluminum rims
|
|
Hendrickson Intraax Air ride suspension with
22500 pound axles |
|
Shur-lok Roll Tarp |
